Maintenace

The space requires minimal maintenance but the items detailed below are required. Use the Blog:Maintenance to log maintenance activities.
Report all findings, issues, questions, and concerns to the makerspace Board of Directors

Maintenance Items

Item	Frequency	Notes
Trash	Weekly	Dumpster is located outside the back of Unit 1. Please do not leave any food trash inside the office. Take it directly to the dumpster
Front Door	Weekly	Confirm door/lock are in good condition. Sweep Entrance
HVAC	Twice per year	There are 3 HVAC zones in the space see details below
Bathroom	Monthly	Check for Leaks Clean sink & toilet Replenish toilet paper & towels
Back Doors	Weekly	Confirm no items blocking the fire exit **Confirm no items blocking the fire exit Make sure the back door fire exit is not blocked
Roll Up Doors	Weekly	Confirm roll up chain is not binding
Back Shops	Weekly	Vacuum & Sweep sawdust and debris	Confirm dust collectors are not full

HVAC Details

There are 2 HVAC zones in the space:

Unit 1

• Thermostat Controls both Heating & Cooling to the office space
• The unit is located above the bathroom.

Unit 2

• Thermostat Controls both Heating & Cooling to the classroom only. The unit is located above the bathroom.

Shop

• Unit 1 furnace provides heat only only to the wood shop.
• Unit 2's furnace has been disabled.

Electrical

• Unit 1
  • Circuit Breakers are located in the utility closet and the wall of the woodshop
• Unit 2
  • Circuit Breakers are located in the front segment of the Metal shop

Fire Protection

Fire Code compliance

Fire Extinguishers: There are seven wall mounted fire extinguishers for the space:

• Unit 1:
  • Front lobby by kitchenette
  • Woodshop by office door
  • Woodshop on pillar by SawStop
  • Woodshop by rear walk-in door
  • Electronics Room near Laser (C02)
  • 3d Printing Room by door